2003-2007 5.9L Cummins S400/Stock Compound Turbo Kit. 1000 RWHP capable, depending upon turbo and fuel system modifications. Recommended for daily driver work trucks and tow rigs looking for increased horsepower, better fuel mileage, and superior EGT control with stock-like turbo spool characteristics. Recommended Combinations - S475 / Stock Holset Turbo - Up to 750 RWHP with Supporting Modifications - Best Turbo Spool, performs well on stock fuel setups. S480 / Stock Holset Turbo - 800+ RWHP Capable with Supporting Modifications - A better top-end performance that sacrifices a bit of spool on the lower end when compared to an S475/stock setup. S480 / 63 or 64 Upgraded Drop-In Turbo - 900+ RWHP Capable with Supporting Modifications - Improved top end power with moderate spool characteristics S480 / 67 Upgraded Drop-In Turbo - 1000+ RWHP Capable with Supporting Modifications - Best Top End Power, sacrifices low-end power and turbo spool - Manual trans trucks will allow best use of power band for this setup. The S480 / 67 upgraded drop-in setup is not recommended for tow rigs due to spool characteristics. Not sure which kit is right for you? Give us a call to discuss your build.
This kit is designed to be used with the OEM exhaust manifold. If you would like to use an aftermarket OEM replacement style manifold like a Steed Speed 3rd Gen T3, ATS, BD or other manufacturer's manifold, you MUST send it to WCFab for the kit to be custom-built, and your kit lead time does not start until the manifold is at WCFab.
Wehrli Custom Fab Twin Turbo Kit S400/Stock, for 2003-2007 Cummins 5.9L, Flat Black
Wehrli 03-07 Dodge 5.9L Cummins S400 Twin Turbo Kit (No Turbo) - Flat Black
Twin Turbo Kit S400/Stock, for 2003-2007 Cummins 5.9L, Flat Black
High Temp Black Ceramic Coating on Hot Side and Down Pipe
Stainless Steel Oil Feed and Drain Lines with Fittings
Dry Air filter with Outerwear's Pre-Filter Cover
Retains passenger-side factory battery location
Turbo Kit S400/Stk 03-07 Cummins FlatBlk
Silicone Boots & Stainless T-Bolt Clamps
3" Cold Charge Pipe Between Turbos
3" Turbo Hot Side Cross Over Pipe
Durable Custom Powder Coat Finish
Installation Hardware Included
Turbochargers sold separately
4" Turbo Down Pipe
Heat Wrap & Clamps
S400/Stk 03-07 FB
Turbocharger Kit
V-Band Clamps
O-ring seals
Made in USA
5" Intake
