This combination of components gives you a huge increase in strength over stock end links.BMR designed the ELK007 sway bar end link kit for street performance, autocross, and road race applications. BMRs heavy-duty adjustable end links are designed to reduce deflection normally seen with stock sway bar end links. End link deflection means reduced sway bar rate, leaving you with increased body roll and reduced handling ability. BMRs ELK007 will not deflect, giving you the full potential of the sway bar no matter how hard you drive. The adjustable links allow for on-car adjustability (front), giving you the ability to easily correct sway bar geometry and working angles on lowered G8s, as well as cars with adjustable sway bars. The ELK007 adjustable end links give you the ability to preload the sway bar to fine-tune your suspension setup for any track. Combine this with BMRs adjustable sway bars, and you can dial-in your car for the street or any track you may drive on. When performance is a must, rely on BMR's suspension!BMR's suspensions ELK007 front and rear sway bar End Link Kit is available in a durable black finish for long-lasting good looks. Installation time is about 1 hour. Proudly made in the U.S.A.!
The amount of force exerted on the sway bar end link is staggering especially if you've upgraded to an aftermarket sway bar, like BMR's suspensions SB029. The stock end links are weak and can bend or break. BMRs ELK007 front and rear End Link Kit allows you to push your 2008-2009 Pontiac G8 to the limit without fear of end link deflection. BMR manufactures the ELK007s out of CNC-machined billet aluminum and heavy-duty steel hex bar stock. The right and left hand threaded ball joint-style tie rods are manufactured by Proforged and offer huge advantages over other companies end links that use rod ends. Ball joints allow for more articulation than a rod end, which is what you want when you hit the track. This ensures long life and flawless operation, and they make less noise than rod ends. The ball joints attach to the sway bar with 12mm studs, while the ball joints attach to the end link tubes with -inch studs.
BMR's heavy-duty adjustable end links are designed to reduce deflection normally seen with stock sway bar end links.
Designed for street performance, autocross, and road race applications
Allows for proper sway bar working angles and geometry on lowered G8s
Allows for preloading of sway bars to fine-tune suspension setup
BMR 14-17 Chevy SS Front and Rear Sway Bar End Link Kit - Black
Dramatically reduces sway bar end link deflection
6061-T6 billet aluminum construction (front)
Designed to withstand high compression loads
Sway Bar End Link Kit, Set Of 4, Adjustable
12mm/1/2-inch studs for increased strength
Heavy-duty steel construction (rear)
Proforged ball joint-style tie rods
Fits all 2008-2009 Pontiac G8s
Suspension Stabilizer Bar Link
Proudly designed in the U.S.A.
Proudly made in the U.S.A.
1-hour installation time
BMR Suspension - ELK007
Sway Bar End Links
Fully CNC-machined
On-car adjustable
