Protect your 1964-1972 GM A-Body, while complying with NHRA safety rules with a Driveshaft Safety Loop from BMR's suspension. If you drag race your Fourth Gen, chances are you need a driveshaft safety loop to be NHRA legal. Built from 1/4-inch laser-cut CNC-formed plate steel, BMRs DSL007 Driveshaft Safety Loop welds-on to the factory floor support located behind the transmission. This design gives you a solidly mounted loop that will stay in place should a driveshaft or transmission failure occur.BMR's suspension designed the Driveshaft Safety Loop to contain a driveshaft, keeping it from ripping through the floor or digging into the track in event of a failure. It simply attaches to the factory driveshaft tunnel brace with supplied Grade 8 hardware. BMR designed the DSL007 for street, drag race, and top speed applications. A Driveshaft Safety Loop is cheap insurance to protect your investment and provide peace-of-mind whether you are at the track or on the street. When performance is a must, rely on BMR's suspension!BMR's suspensions DSL007 weld-on Driveshaft Safety Loop is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 2 hour. Proudly made in the U.S.A.!
BMR Suspension designed the DSL007 Driveshaft Safety Loop to contain a driveshaft, keeping it from ripping through the floor or digging into the track in event of a failure.
Required for cars quicker than 13.99 in the quarter mile with sticky tires
Required for cars quicker than 11.49 in the quarter mile with stock tires
Available in black hammertone and red powdercoat
BMR 68-72 A-Body Driveshaft Safety Loop - Red
1/4-inch laser-cut plate steel
Proudly designed in the U.S.A.
Proudly built in the U.S.A.
Durable powdercoat finish
Fits 1968-1972 GM A-Body
BMR Suspension - DSL007R
Complies with NHRA rules
Driveshaft Safety Loop
Drive Shaft Loop
Weld-on design
Safety Loop
