The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB345 rear sway bar was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-wall 29mm DOM tubing, the SB345 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. The SB345 attaches to your 1982-2002 F-Body with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keeps grease in the bushing. The fabricated laser cut, TIG-welded steel sway bar end links are reinforced to minimize deflection.BMR's suspension designed the SB345 sway bar for street performance, drag race, and road race applications. The large adjustable sway bar has two positions, giving you the versatility to drive to and from the track and still out handle the competition with the same sway bar. The SB345 gives you a 290%-394% increase in rate over the stock bar. These rate increases and adjustability allow you to fine-tune the handling characteristics of the suspensions you can drive harder through corners with minimal body roll. The hollow design allows for loads of strength without adding a lot of weight. This allows for more sway bar control, which equals better handling. When performance is a must, rely on BMR's suspension!BMR's suspensions SB345 sway bars are available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!
BMR Suspension designed the SB345 sway bar kit for street performance, autocross, and road race applications.
BMR 82-02 F-Body Rear Hollow 29mm Adjustable Sway Bar Kit - Black Hammertone
Designed for street performance, autocross, and road race applications
Manufactured from 29mm heavy-wall DOM tubing for increased strength
Sway Bar Kit, Rear, Hollow 29mm, Adjustable, Stamped Steel Bracket
290%-394% increase in sway bar rate over stock sway bar
Adjustability allows for fine-tuning of suspension
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
Cold formed to better resist torsional fatigue
88-durometer, greasable polyurethane bushings
Dramatically reduces body roll
Proudly designed in the U.S.A.
1/4" Formed sway bar saddles
1-2-hour installation time
Proudly made in the U.S.A.
Durable powdercoat finish
Fits 1982-2002 GM F-body
BMR Suspension - SB345H
Sway Bar Kit
