Hard launches from high horsepower cars at the drag strip require more than just a normal street-style sway bar. BMR's suspensions Xtreme Anti Roll Bar for 1982-2002 GM F-body allows you to launch harder without excessive body roll limiting traction, with little sacrifice to your Camaros street manners. Manufactured from heavy-wall 1.375-inch DOM tubing, BMRs Xtreme Anti Roll Bar (XSB001) is designed to eliminate body roll and transfer as much power as possible to the rear wheels. The XSB001 attaches to your F-body with polyurethane bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing under high compression loads. BMR's suspension designed the XSB001 sway bar for street performance and drag race applications. The large adjustable sway bar has two positions, giving you the versatility to drive to and from the track with the same sway bar. The XSB001 gives you a massive increase in rate over the stock bar (depending on year and model). These rate increases and adjustability allow you to almost eliminate body roll so you can leave the starting line harder with maximum traction. The hollow design gives you loads of strength without adding a lot of weight. When performance is a must, rely on BMR's suspension!BMR's suspensions XSB001 anti roll bar is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!
BMR Suspension designed the XSB001 anti-roll bar for drag race and limited street applications.
BMR 82-02 3rd Gen F-Body w/ 3.0-3.25in Axles Rear Hollow 1.375in Xtreme Anti-Roll Kit - Red
Massive increase in sway bar rate over stock sway bar (depending on year and model)
Manufactured from 1.375-inch heavy-wall DOM tubing for increased strength
Xtreme Anti-roll Kit, Rear, Hollow 1.375", 3" Or 3.25" Axles
Designed for street performance and drag race applications
Adjustability allows for fine-tuning of suspension
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
Cold formed to better resist torsional fatigue
88-durometer, greasable polyurethane bushings
Two-way adjustable for street and track use
Dramatically reduces body roll
Proudly designed in the U.S.A.
Fits 3" and 3.25" axle tubes
1-2-hour installation time
Proudly made in the U.S.A.
Durable powdercoat finish
Fits 1982-2002 GM F-body
BMR Suspension - XSB001R
100% bolt-in design
Anti-roll Bar Kit
