BMR's suspension designed the SB052 sway bar kit for street performance, autocross, and road race applications. The large adjustable sway bars three positions give you the versatility to drive to and from the road course or autocross and still out handle the competition with the same sway bars. The SB052 front sway bar gives you a 33%-96% increase in sway bar rate, and the rear bar gives you a 73%-125% increase in rate over the stock bar. These rate increases and adjustability allow you to fine-tune the handling characteristics of your Camaro so you can drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB052 attaches to your Camaro with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, which equals better handling. BMR's adjustable sway bars are also available in front only (SB053) and rear only (SB054). When performance is a must, rely on BMR's suspension!BMR's suspensions SB052 sway bar kit is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 3-4 hours. Proudly made in the U.S.A.!Does Not Fit Convertible Cars
The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB052 front and rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 1.25-inch (front) and 1.25-inch (rear) DOM steel tubing, the SB052 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. Thrust washers are welded to the front bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB052 attaches to your Sixth Gen Camaro with polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing.
BMR Suspension designed the SB052 sway bar kit for street performance, autocross, and road race applications.
62%-297% increase in sway bar rate (front), 52%-198% increase is sway bar rate (rear)
Manufactured from 1.25-inch heavy-wall DOM tubing for increased strength
Designed for street performance, autocross, and road race applications
BMR 16-18 Chevy Camaro Sway Bar Kit w/ Bushings - Black Hammertone
Fits 2016-Newer Chevrolet Camaro(excluding cars with ELSD)
Sway Bar Kit With Bushings, Front (SB053) And Rear (SB054)
Adjustability allows for fine-tuning of suspension
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
Billet aluminum, black anodized bushings saddles
High durometer, greasable polyurethane bushings
Cold formed to better resist torsional fatigue
Three-way adjustable for street and track use
Dramatically reduces body roll
Proudly designed in the U.S.A.
3-4 hour installation time
Proudly made in the U.S.A.
Zinc-plated inner sleeves
Durable powdercoat finish
BMR Suspension - SB052H
Sway Bar Kit
