These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing.BMR's suspension designed the SB051 sway bar kit for street performance, autocross, and road race applications. The large sway bars single position give you the ability to drive to and from the road course or autocross and still out handle the competition with the same sway bars. The SB051 rear bar gives you a 52 increase in rate over the stock bar. This rate increase allows you to drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB051 attaches to your Camaro with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, which equals better handling. When performance is a must, rely on BMR's suspension!BMR's suspensions SB051 sway bar kit is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!Does Not Fit Convertible Cars
The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB051 rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 1.25-inch DOM steel tubing, the SB051 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. Thrust washers are welded to the front bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB051 attaches to your Sixth Gen Camaro with polyurethane bushings, reducing the deflection from the stock rubber bushings.
BMR Suspension designed the SB051 sway bar kit for street performance, autocross, and road race applications.
BMR 16-17 6th Gen Camaro Rear Hollow 32mm Non-Adj. Sway Bar Kit - Black Hammertone
Manufactured from 1.25-inch heavy-wall DOM tubing for increased strength
Designed for street performance, autocross, and road race applications
Fits 2016-Newer Chevrolet Camaro(excluding cars with ELSD)
Sway Bar Kit With Bushings, Rear, Hollow, Non-adjustable
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
52% increase in sway bar rate over stock sway bar
Cold formed to better resist torsional fatigue
88-durometer, greasable polyurethane bushings
Dramatically reduces body roll
Proudly designed in the U.S.A.
1-2 hour installation time
Proudly made in the U.S.A.
Zinc-plated inner sleeves
Durable powdercoat finish
BMR Suspension - SB051H
Sway Bar Kit
