The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB043 front and rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 35mm (front) and 25mm (rear)DOM steel tubing, the SB043 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality.Thrust washers are welded to the front bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB043 attaches to your S550 Mustang with polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing.BMR's suspension designed the SB043 sway bar kit for street performance, autocross, and road race applications.
The large adjustable sway bars three positions give you the versatility to drive to and from the road course or autocross and still out handle the competition with the same sway bars. The SB043 front sway bar gives you a 28%-70% increase in sway bar rate, and the rear bar gives you a 63%-208% increase in rate over the stock bar. These rate increases and adjustability allow you to fine-tune the handling characteristics of your S550 Mustang so you can drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB043 attaches to your Mustang with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, which equals better handling. When performance is a must, rely on BMR's suspension!BMR's suspensions SB043 sway bar kit is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 2-3 hours. Proudly made in the U.S.A.!
BMR’s Sway Bar Kit (SB043) increases sway bar rate and is designed for street performance, autocross, and road racing applications.
BMR 15-17 S550 Mustang Front & Rear Sway Bar Kit w/ Bushings - Black Hammertone
Available in red or black hammertone powder coat for long lasting good looks
Greater sway bar control allows for better handling of your vehicle
Adjustability allows for fine-tuning of your vehicle's suspension
Manufactured from 35mm (Front) and 25mm (Rear) DOM steel tubing
19-55% (Front) and 63-208% (Rear) increase in sway bar rate
Sway Bar Kit With Bushings, Front (SB044), Rear (SB045)
Greaseable 88- and 95-durometer polyurethane bushings
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
Cold-formed to better resist torsional fatigue
Three-way adjustable for street and track use
Includes both SB044 (Front) and SB045 (Rear)
Fits 2024-Current S650 Mustangs
Dramatically reduces body roll
Fits 2015-2023 S550 Mustangs
Proudly designed in the USA!
2-3 hour installation time
Includes Grade 8 hardware
Proudly made in the USA!
BMR Suspension - SB043H
Sway Bar Kit
