The sway bar is 3-way adjustable to tune the amount of torsional spring rate and to determine the handling characteristics (understeer/oversteer) of the vehicle.BMR's suspension designed the SB044 sway bar for street performance, autocross, and road race applications. The large adjustable sway bars three positions give you the versatility to drive to and from the road course or autocross and still out handle the competition with the same sway bar. The SB044 front sway bar gives you a 19%-55% increase in sway bar rate. These rate increases and adjustability allow you to fine-tune the handling characteristics of your S550 Mustang so you can drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB044 attaches to your Mustang with 95-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, and more control equals better handling. When performance is a must, rely on BMR's suspension!BMR's suspensions SB044 sway bars are available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!
The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB044 S550 Mustang front sway bar was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-wall 35mm DOM tubing, the SB044 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. Thrust washers are welded to the bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers. The sway bar mounts to the car using polyurethane bushings. These bushings are molded from 95-durometer, low-deflection, polyurethane, and are internally fluted to keeps grease in the bushing. The billet aluminum sway bar mounting brackets minimize deflection.
BMR’s 3-Hole Adjustable Front Sway Bar (SB044) increases sway bar rate and is designed for street performance, autocross, and road racing applications.
Thrust washers allow for proper location of the sway bar and prevent lateral movement
Available in red or black hammertone powder coat for long lasting good looks
BMR 15-17 S550 Mustang Front Hollow 35mm 3-Hole Adj. Sway Bar Kit - Red
Greater sway bar control allows for better handling of your Mustang
Adjustability allows for fine-tuning of your vehicle's suspension
Sway Bar Kit, Front, Hollow, 35mm, 3-hole Adjustable
Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit
Three-hole adjustable for street and track use
Cold-formed to better resist torsional fatigue
Greaseable, 95-durometer polyurethane bushings
Manufactured from 35mm DOM steel tubing
19-55% increase in sway bar rate
Fits 2024-Current S650 Mustangs
Dramatically reduces body roll
Fits 2015-2023 S550 Mustangs
Proudly designed in the USA!
1-2 hour installation time
Proudly made in the USA!
BMR Suspension - SB044R
Sway Bar Kit
